Tips For Sticking Self-adhesive Stickers

Tips for sticking self-adhesive stickers
Tips and Common Problems for Applying Adhesive Stickers
Applying ETIE adhesive stickers on the car shell, although seemingly simple, requires a certain level of skill to achieve both straightness and smoothness. Especially when dealing with large ADHESIVE STICKERs, it is necessary to be cautious and careful. If the method of directly tearing off the entire back sticker and then sticking it on is adopted, it is not only easy to get fingerprints on it, but also may cause the sticker to stick and be difficult to control. If the direction is incorrect and needs to be readjusted, it may also deform due to the sticker being too soft.
▍ Common problems
Applying etie stickers on the car body may seem simple, but it requires skills to avoid common issues such as fingerprint residue, sticker deformation, and difficulty in handling.
Recommended steps
A more recommended approach is to carefully lift a small portion of the back sticker from one corner of the sticker (if necessary, it can be pre cut), then align the position carefully and gradually stick the exposed sticker onto the vehicle body. After confirming that the position is correct, gradually tear off the back sticker and stick it on until it is completely covered.
In the process of pasting stickers, the principle from inside to outside should be followed, that is, first paste the middle part, and then press outward with your fingers to squeeze out the bubbles.
▍ Precautions for operation
If applied from the outside to the inside, bubbles may be difficult to avoid (in this case, for aesthetic reasons, a small knife can be used to gently cut the bubble part). In addition, soap water can be pre applied to the car shell, which not only adjusts the position, but also pushes the bubbles from the middle to the edge and discharges them. Please note that the soapy water applied will naturally dry out after half a day. During this process, avoid touching it and ensure a firm bond after it dries.
During the pasting process, air bubbles should be pressed out from the inside out. The position can be adjusted in advance with soapy water and the bubbles should be expelled. After it dries, avoid touching it. This final EITE decoration will bring a great decorative effect to your car.